Allow the system up to 10 minutes to complete its startup and signal acquisition process. 2. Check for Signal Obstructions
The "source" wasn't the probe. The probe was just a relay. The source was the massive, distortion-less shadow behind the probe—a shadow that was rapidly growing larger as the Aethelgard was pulled closer. dish stuck on acquiring signal 535
The indicates that your receiver has lost its connection to the satellite and is struggling to re-establish it. While the on-screen message typically suggests this process "should take no more than a few minutes," being stuck on this screen indefinitely usually points to a physical signal blockage, loose wiring, or hardware failure. 1. Perform a Hard Power Reset Allow the system up to 10 minutes to
A micro-asteroid, no bigger than a grain of sand, had punched a clean hole through the receiver horn. But that wasn't why it was stuck. The impact had jarred the focusing lens, wedging it against the gimbal. The dish was trying to turn, grinding the gears against the obstruction, unable to lock onto the vector. The probe was just a relay
Follow these detailed steps to troubleshoot and resolve the issue: 1. Perform a Power Reset